2 connect the speaker cables, 02 install your flat panel tv – Pioneer KURO PRO-151FD Manuel d'utilisation

Page 22

Advertising
background image

22

En

02

Install Your Flat Panel TV

8 ) Insert the cable in the groove on the speaker.

9 ) Connect the other end of the speaker cables to the rear of the panel.

Refer to 2.2.2 Connect the Speaker Cables.”

Note: If the speaker needs to be repositioned (horizontally or vertically) after it is attached, loosen the speaker

mounting screws first. Adjust the position then retighten the screws.

2.2.2 Connect the Speaker Cables

1 ) Press down on the tab.

2 ) Insert the appropriately colored wire into the opening.

3 ) Allow a small percentage of the cable’s bare wire to remain visible.

4 ) Release the tab to clamp the wire.

If the bare wire is hidden when the tab is released, repeat Steps 1
through 4 until the proper amount of cable is showing.

5 ) Repeat this process for each cable, matching the color of the wire to the

appropriate terminal.

6 ) Connect the speaker cables to the speaker.

7 ) Bundle the speaker cables, power cord and other cables in the cable

clamp then insert the clamp into an appropriate hole on the rear of the
flat panel TV.
Refer to “2.7 Route then Bundle the Power Cord and Cables.”
Use the clamps as necessary (see page 33).

Speaker cable

(PRO-111FD)

(PRO-151FD)

Speaker
terminal

Insertion
in groove

Speaker cable

Speaker terminal

Insertion
in groove

tab

Gray

Speaker cable

Gray

Black

Speaker terminal

Black

Red

Red

(PRO-151FD)

PRO151FD.book Page 22 Wednesday, April 2, 2008 10:19 AM

Advertising
Ce manuel est liée aux produits suivants: