02 install your flat panel tv – Pioneer KURO PRO-151FD Manuel d'utilisation

Page 28

Advertising
background image

28

En

02

Install Your Flat Panel TV

(when side-mounted speakers are not installed)

1 ) Remove the screws of the color sensor then replace the bracket.

Use the removed screws again.

2 ) Finger tighten the supplied color sensor screws in the speaker screw holes.

3 ) Fit the color sensor bracket’s lower grooves into the screws.

Adjust the bracket position to stay in place.

4 ) Fasten the screws.

5 ) Connect the cable to the color sensor terminal on the rear upper bank but do NOT plug in to the power outlet.

Important

The color sensor may not operate properly:

• if attached by methods other than specified above

• if anything blocks light falling on the sensor window

• if light falls on only part of the sensor window

• if the light falling on the sensor window and the panel screen differs

Notes: If the color sensor attached to the rear panel does not operate properly, attach it to the front panel.

The color sensor may become hot due to a heat emitted from the panel. When using it in a high-
temperature environment, attach the color sensor to the bottom of the front panel.
Do not use the screws supplied for the speakers.

The bracket is for PRO-151FD panel but the procedure is the same for PRO-111FD.

PRO151FD.book Page 28 Wednesday, April 2, 2008 10:19 AM

Advertising
Ce manuel est liée aux produits suivants: