Messages – Sony MZ-N707 Manuel d'utilisation

Page 73

Advertising
background image

73

-GB

Messages

If the following messages flash in the display window, check the messages below.

Error message Meaning/Remedy

BLANKDISC

• An MD with no recording on it is inserted.

BUSY

• You tried to operate the recorder while it was accessing the recorded

data.
, Wait until the message goes out (in rare cases, it may take a few

minutes).

Data Save

• The MD player is recording information (sounds) from the memory

to the disc.
, Wait until this process is completed. Do not expose the player to

any physical shock, nor disrupt power supply.

DISC FULL

• The remaining recording time on the disc is 12 seconds (stereo), 24

seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
, Replace the disc.

Hi DC in

• Voltage of the power supply is too high (The supplied AC power

adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car

battery cord.

HOLD

• The recorder is locked.

, Slide HOLD against the arrow to unlock the recorder (page 58).

LOW BATT

• Battery is weak.

, Charge the rechargeable battery or replace the dry battery

(page 15).

MEM OVER

• You tried to record with the recorder placed where it receives

continuous vibration.
, Put the recorder on a stable place, and start recording again.

NAME FULL

• You tried to enter more than 200 letters to label a single track or disc.
• You tried to enter a total of more than 1700 letters for track or disc

names.
, Enter a shorter name for the track, group, or disc (page 47), or set

the “LP Stamp” setting to “Stamp OFF” so that “LP:” is not
added at the beginning of the track name (page 28).

NO BATT

• The rechargeable battery is not inserted.

, Insert a rechargeable battery.

NO COPY

• You tried to make a copy from a disc that is protected by the Serial

Copy Management System. You cannot make copies from a digitally
connected source which was itself recorded using digital connection.
, Use analog connection instead (page 27).

NO DISC

• You tried to play or record with no disc in the recorder.

, Insert an MD.

Advertising