Sony MZ-N707 Manuel d'utilisation

Page 66

Advertising
background image

66

-GB

The recorder does
not work or works
poorly.

• The disc is record-protected (“PROTECTED” appears).

, Slide the tab (page 61).

• Recording level is too small to record (when recording

manually).
, Pause the recorder and adjust the recording level.

• A Premastered MD is inserted (“P/B ONLY” appears) when

recording.
, Insert a recordable MD

• The recorder is operated when it is on a battery charging stand.

, Remove the recorder from the battery charging stand.

• You tried to turn group mode on while setting the program.

, Turn group mode on before setting the program.

The recorder
overwrites existing
materials when
record.

• The record starting-position setting (“REC-Posi”) is set to

“From Here”.
, Set “REC-Posi” setting to “From End”.

The recorder does
not work while
connected to the
computer.

• The computer does not recognize the recorder.

, Verify that the recorder is correctly connected.
, Place the recorder correctly on the battery charging stand.
, Install the driver correctly into your computer.
, Install the OpenMG software into your computer first, and

then connect the recorder.

“NO SIGNAL”
appears in the display
when recording from
a portable CD player.

• There is no digital signal from the portable CD player.

, When recording digitally from a portable CD player, use the

AC power adaptor and disable the anti-skip function (such as
ESP) on the CD player (page 21).

There is no recording
on the MD after a
recording operation.

• The AC power adaptor was unplugged or a power outage

occurred during recording.

The lid does not
open.

• The power sources have been disconnected during recording or

editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery

with new ones.

• The lid is not firmly closed.

, Close the lid until it clicks. Then press OPEN to open the lid.

No sound comes
through the
headphones/
earphones.

• The headphones/earphones plug is not firmly connected.

, Plug in the plug of the headphones/earphones firmly to the

remote control. Plug in the plug of the remote control firmly
to i.

• Volume is too low.

, Adjust the volume by pressing VOL +/–.

• The plug is dirty.

, Clean the plug.

Symptom

Cause/Solution

Advertising