Fisher & Paykel CG365C - Manuel (Page 15)

13
Installation instructions
Converting to a different gas type
Gas regulator
For use with a gas pressure regulator as shown below. The regulator supplied can be set for
either LP Gas or Natural Gas.
Converting the regulator between NG & LP
1 Unscrew the cap from the regulator.
2 Check the orientation of the plastic conversion plug, and if necessary, unscrew, turn over and
screw back in (wide section away from cap for LP and against cap for NG - see diagram below for
appropriate orientation).
3 Replace regulator cap.
4 Test gas pressure (test point provision on side of regulator). When converting the regulator for
different settings, the function of the regulator must be checked at a pressure at least 1” WC
(0.036 psi) above the specified manifold pressure.
Cooktop
To Cooktop
Regulator
Solid or Flexible
Connector
Shut-Off
Valve
Pipe Stub from
House supply
Pressure
Regulator
shows
Direction of
Gas Flow
LP NG
US
CA
(EN)