Epson WorkForce 845 - Manuel (Page 30)

30 Replacing Ink Cartridges
7. Insert the new ink cartridge into the holder and push it down until it clicks into place.
Once you replace all the cartridges that need replacing, close the cartridge cover and
push it down until it clicks into place.
8. Lower the scanner to begin priming the ink. This takes a few minutes.
When you see a completion message on the LCD screen, ink priming is finished.
Caution: Never turn off the product while ink is priming or you’ll waste ink. If you see
an ink replacement message on the LCD screen, press OK and press down all the
cartridges securely. Then press OK again. If you remove a low or expended ink
cartridge, you cannot reinstall and use the cartridge.
Note: If you replaced a cartridge while copying a document or photo, cancel printing
and make sure your original is still placed correctly on the document table. Then copy
your original again.
Cassini_QG.book Page 30 Monday, June 20, 2011 3:22 PM