Epson WorkForce 845 - Manuel (Page 20)

20 Sending a Fax From the Control Panel
Sending a Fax From the Control Panel
You can send a fax by manually entering a fax number, as described below.
Note: To dial the number using a telephone, by redialing, or by selecting from your
speed dial list, see the next section. To send a fax from your computer using the Epson
FAX Utility, see your online User’s Guide.
1. Place your original(s) for faxing (see page 7).
2. Press , if necessary, and select Fax .
To fax a two-sided document, place your document in
the ADF. Press x Menu and select
Fax Send
Settings . Then press 2-Sided Scanning and select
On .
3. Press , then use the numeric keypad to enter the
fax number (up to 64 digits). Then press OK .
4. Select Color or B&W .
Note: If the recipient’s fax machine prints only in black and white, your fax is
automatically sent in black and white even if you select Color.
5. Press OK , if desired, to see a summary of your fax transmission settings.
6. Press x to begin scanning and faxing your document. (To cancel, press y.)
■ If you are scanning with the ADF (see page 7), your document is automatically
scanned and faxed.
■ If you placed your document on the scanner glass, you can scan additional pages
after the first one is sent.
■ If the fax number is busy, you see a redialing message and the product redials
after one minute. To redial immediately, press
Redial .
Note: If you turn off the product, the following data stored in the product’s temporary
memory will be lost: received faxes that haven’t yet been printed, faxes scheduled to
be sent later, and faxes being retransmitted automatically.
Receiving Faxes
Before receiving faxes, make sure you load plain paper and select the correct settings for the
paper you’ve loaded.
1. Press if necessary and select Setup .
2. Press l or r and select Fax Settings .
3. Select Scan & Print Setup .
Cassini_QG.book Page 20 Monday, June 20, 2011 3:22 PM