Accu-Chek Aviva NANO - Manuel (Page 25)

Meter Memory, Setup, and Data Transfer
3
23
Press and release to
turn the meter on.
The flashing test strip
symbol appears on the
display.
Press and
hold until
set-up appears on the
display.
1 2
Press and release
repeatedly until the bell
symbol, OFF, set-up,
and the flashing A-1
appear on the display.
Press and release or
to switch between On
and OFF.
Press and release to
set your choice.
If
On is selected, the
hour flashes.
3
Press and release or
to adjust the hour.
Press and release to
set the hour.
The minutes flash.
4
NOTE
Test reminders:
• beep at the same time each day.
• beep every 2 minutes up to 3 times.
• turn off by inserting a test strip or pressing any button.
• If a test was performed within 15 minutes of a test reminder, the test reminder does not beep.
• If the meter is on at the test reminder time, the test reminder does not beep.
• Exposure to cold conditions may disable test reminders until the meter is turned on.
• If a test reminder is off in set-up mode, any subsequent test reminders are also off. For example, if
you set A-1 but turn off A-2, then A-3 and A-4 will automatically be off.
Setting the Test Reminders
51689_05958458003_CA_EN.indb 23 9/3/13 4:10 PM