Cadillac 2010 CTS - Manuel (Page 17)

Keys, Doors and Windows 1-11
13. A beep sounds once
programming is complete.
The DIC displays Ready
To Learn Electronic Key # 2.
To program additional
transmitters, insert each
transmitter in the pocket until
a beep is heard and the
DIC advances to the next
electronic key number. Up to
four transmitters can be
programmed. The DIC displays
Maximum # Electronic Keys
Learned and exits the
programming mode.
Press the ignition control knob
to complete the process.
14. Press the ignition control knob
if programming is complete.
15. Press
K
on each newly
programmed transmitter to
complete the process.
Starting the Vehicle with a Low
Transmitter Battery
Replace the battery if the Replace
Battery In Remote Key message
displays in the DIC. See “Replace
Battery In Remote Key” under Key
and Lock Messages on page 4‑42
for additional information.
If the transmitter battery is weak, the
DIC may display Electronic Key Not
Detected when you try to start the
vehicle. To start the vehicle, place
the transmitter in the center console
storage area transmitter pocket with
the buttons facing to the front of the
vehicle. Then, with the vehicle in
P (Park) or N (Neutral), press the
brake pedal and the ignition control
knob. See Starting the Engine on
page 8‑20, for additional
information about the vehicle's
electronic keyless ignition with push
start. Replace the transmitter battery
as soon as possible.
Battery Replacement
Notice: When replacing the
battery, do not touch any of the
circuitry on the transmitter.
Static from your body could
damage the transmitter.
1. Separate the transmitter with a
flat, thin object inserted into the
slot on the side or back of the
transmitter.
2. Remove the old battery. Do not
use a metal object.