Cadillac 2010 CTS - Manuel (Page 109)

Storage 3-9
9. Levers must still be in the
forward up position. For front
crossbar, slide the crossrail
assembly (A) forward until the
crossrail end is past the channel
cut-out area (B). For rear
crossbar, slide the crossrail
assembly (A) rearward until the
entire crossrail support is in
first position to the rear of the
channel cut-out area (B).
10. Move the levers on both
crossrail supports to the down
position. Slide the crossrail
assembly back and forth until
the crossrail pin engages.
11. Push back and forth again to
make sure the pins have
engaged into the slots.
Make sure both crossrails are
locked into the same hole
position on each side of the
vehicle.
Removing the Crossrails
1. Start with either crossrail
assembly, slide both levers into
the upper most position, moving
the lever from the rear to the
front of the vehicle.
2. Slide the crossrail assembly until
it is in the cut-out area or the
siderail channel.
3. Remove the crossrail from the
vehicle.
4. Repeat steps 1–3 for the other
crossrail assembly.
5. Reinstall the siderail covers
making sure they are fully
seated in the siderail channel.