Ride control system messages, Ride control system, Messages -42 – Cadillac 2012 CTS Manuel d'utilisation

Page 172: 42 instruments and controls

Advertising
background image

Black plate (42,1)

Cadillac CTS/CTS-V Owner Manual (Include Mex) - 2012

5-42

Instruments and Controls

SERVICE SIDE BLIND ZONE
ALERT SYSTEM

If this message appears, both SBZA
displays will remain on indicating
there is a problem with the SBZA
system. If these displays remain on
after continued driving, the system
needs service. Take the vehicle to
your dealer.

SIDE BLIND ZONE ALERT
SYSTEM OFF

This message indicates that the
driver has turned the system off.

SIDE BLIND ZONE ALERT
SYSTEM TEMPORARILY
UNAVAILABLE

This message indicates that the
SBZA system is disabled because
the sensor is blocked and cannot
detect vehicles in the blind zone.
The sensor may be blocked by
mud, dirt, snow, ice, or slush.

This message may also activate
during heavy rain or due to road
spray. The vehicle does not need
service. For cleaning, see Exterior
Care on page 10‑118
.

Ride Control System
Messages

ALL WHEEL DRIVE OFF

If the vehicle has the All-Wheel
Drive (AWD) system, this message
displays when there is a temporary
condition making the AWD system
unavailable. The vehicle will run in
2WD. This could be caused by:

.

Loss of wheel or vehicle speed

.

AWD system overheat

.

Certain vehicle electrical
conditions

This message turns off when the
above conditions are no longer
present and the warning message
is reset.

To reset the warning message,
turn the ignition off and then back
on again after 30 seconds. If the
message stays on, see your dealer
right away. See All-Wheel Drive on
page 9‑35
for more information.

SERVICE ALL WHEEL DRIVE

This message displays if a problem
occurs with the All-Wheel Drive
(AWD) system. The vehicle will run
in 2WD. This could be caused by:

.

An electronics problem

.

An AWD system oil overheat

.

Worn out or overheated clutch
plates

.

Various electrical issues

If this message appears, stop as
soon as possible and turn off the
ignition for 30 seconds. Restart the
vehicle and check for the message
on the DIC display. If the message
still displays or appears again when
you begin driving, the system needs
service. See your dealer right away.

Advertising