Philips 10000241 - Manuel (Page 30)

27
ERROR CODES
GUIDE MESSAGE THAT APPEARS HOW TO REMOVE THE MESSAGE
out of service (xx)
restart to fix… Where (xx) identifi es an error code.Turn off and after 30
seconds turn the machine on again to restore normal operation.
If the problem persists, call Saeco or an authorized service
centre and give the code (xx) shown on the display.
close coffee bean lid
Close the coffee bean lid to be able to make a beverage.
fill container wth coffee Put coffee beans into the bean hopper.
insert the brew group Insert the Brew Group in its place (see page 26).
insert grounds drawer Insert the coffee grounds drawer.
empty grounds This preliminary warning does not stop the machine from
functioning. Proceed until the next message appears.
empty grounds drawer Remove the grounds drawer and dispose of the used coffee
grounds (see page 25 steps 1 and 2).
Note: The grounds drawer must be emptied only when the
machine requires it and when the machine is turned on. If
you empty the drawer with the machine turned off it will not
reset the count of cycles.
close door
In order for the machine to operate, the side service door must
be closed.
fill the water tank. The tank must be removed and refi lled with fresh drinking water.
empty drip tray
Open the side service door and empty the drip tray located
under the Brew Group.
WARNING: WHENEVER THIS MESSAGE APPEARS, BE
SURE TO EMPTY THE COFFEE GROUNDS DRAWER AS
WELL.
change the filter The water fi lter must be replaced in the following cases:
1. 60 litres of water have been dispensed;
2. 60 days have passed since its installation;
3. 20 days have passed after the machine’s last use.
Note: this message only appears when the fi lter alarm function
has been set to “on” (see page 19, menu 2.4).
carafe missing
milk island missing
The steam knob has been turned to the position and either
the Milk Island has not been installed or the carafe is not
positioned correctly. Install the Milk Island or position the carafe
correctly.
Otherwise, turn the knob until it is in the rest position ( ).
descale A descaling cycle must be performed on the machine’s internal
circuits (see page 22).
stand-by… Press the button.