Breville the YouBrew Glass BDC550XL - Manuel (Page 10)

18 19
USInG tHE yoUBREw ® GLASS - SInGLE CUP MoDE USInG tHE yoUBREw ® GLASS - SInGLE CUP MoDE
3. Select ‘Single Cup’ Mode
Press the SINGLE CUP button. The LCD
screen will display a cup symbol and the
current cup size selected. Continue pressing
the SINGLE CUP button to select the
desired size.
There are 9 size options to accommodate
for different amounts or milk, half-and-
half and creamer. Below is a guide to the
amount brewed at each setting. Always
ensure your cup is an adequate size for the
setting selected.
SEttInG AMoUnt BREwED
1 ~ 7.5oz
2 ~ 9.5oz
3 ~ 11oz
4 ~ 12.5oz
5 ~ 14.5oz
6 ~ 16oz
7 ~ 17.5oz
8 ~ 19.5oz
9 ~ 21oz
The amounts above are approximate only.
Actual amounts may vary due to the type of
filter used, the coffee bean size, roast, blend
and freshness, or amount and type of pre-
ground coffee used.
4. Select the Brew Strength or
‘PRE-GRoUnD’ Coffee Setting
Press the STRENGTH | FLAVOR button.
The LCD screen will flash the current
strength setting and the and buttons
will illuminate and flash. Use these buttons
to cycle through 7 strength settings from
‘MILD’, ‘STRONG’ to ‘INTENSE’ or for the
‘PRE-GROUND’ coffee setting.
Press the STRENGTH | FLAVOR button to
select. The LCD screen will flash the current
flavor setting.
notE
If using pre-ground coffee, select the
‘PRE-GROUND’ coffee setting. This
will disable the burr grinder. Add
pre-ground coffee to the gold tone
filter or a paper filter (8-12 cup, flat
base basket style with ~ 3¼"/8.25cm
base). We recommend 1 level
tablespoon of pre-ground coffee per
5oz/150ml cup of water. Adjust the
amount according to your individual
taste. The maximum capacity for
pre-ground coffee is 16 level
tablespoons. Exceeding this amount
may cause overflow.
5. Select the Flavor Setting
Press the STRENGTH | FLAVOR button
until the LCD screen flashes the current
flavor setting and the and buttons
illuminate and flash. Use these buttons to
cycle through 5 flavor settings from ‘LITE’
to ‘BOLD’. These settings vary the steeping
time of the coffee and water. The ‘LITE’
setting steeps for less time to produce
a light-flavored cup. The ‘BOLD’ setting
steeps for more time for a bolder, more
full-flavored coffee.
Press the STRENGTH | FLAVOR button
to select. The LCD screen will cease to
flash once selected.
6. Start the Brew Cycle
Press the START | CANCEL button.
The grinder will commence grinding
the correct amount of coffee for the
selected brew size and strength. If the
‘PRE-GROUND’ coffee setting has been
selected, the grinder will be disabled.
notE
Steam may emit from the rear steam
vent during grinding and brewing.
This is normal.
The count-down timer will then begin. The
time displayed is an estimate only and will
depend on the amount, strength and flavor
settings you have selected. The LCD screen
will display:
a) ‘PRE-HEATING’ as the water is heated
to the optimal temperature. The
pre-heating time will depend on the
starting temperature of the water in
the water tank.
b) ‘STEEPING’ as coffee and water are
steeped together.
c) ‘BREWING’ as the coffee is dispensed
into the cup.
To stop the cycle at any time, press the
START | CANCEL button. You will hear
a winding sound. This is normal.
CAUTION
Never open the swing-out door
and remove the coffee basket while
brewing. Hot water and coffee can
cause injury.
7. Empty the Coffee Basket
Once the brewing cycle is complete, the
ready signal will sound and a winding sound
will be heard. This is normal. The coffee
machine will automatically shut-off, however
the LCD screen will flash ‘EMPTY COFFEE
FILTER’ as a reminder to remove the coffee
basket and discard the used grinds. Wash
the coffee basket, taking particular care to
rinse the chute area. Then dry the coffee
basket and chute area thoroughly.
We also recommend checking the coffee
grinds chute disc for any build-up of coffee
grinds. This is the stainless steel disc that is
visible when the swing-out door is opened.
A build-up of grinds on this disc can affect
the performance of the machine. Wipe the
disc clean then dry thoroughly.
CAUTION
The coffee basket, gold tone or paper
filter may still be very hot after
brewing. Use caution and allow to
cool before removing.
notE
If using the gold tone filter, you
may notice the brewing cycle finish
before the ready signal sounds.
This is normal. The total brewing
time displayed on the LCD screen is
calculated using paper filters as coffee
passes through paper filters slower.
8. warming Plate
The warming plate will automatically
turn on during the brewing process then
automatically turn off after brewing is
complete. Use caution as the warming
plate will be hot during brewing and for
approximately 5 minutes after brewing.
CAUTION
Use caution when removing the cup
from the warming plate as both the cup
and warming plate will be hot.