Napoleon Fireplaces S9 - Large Stove - Manuel (Page 22)

W415-1226 / 06.27.13
22
EN
5.4 ASH DRAWER ADJUSTMENT
NOTE: If ash drawer adjustment is necessary there are adjustment areas located on the sides and bottom of
the ash drawer, as illustrated below.
A. Remove the ash drawer from the appliance by pressing the drawer disconnect lever down on the right
side and upwards on the left side then pull the ash drawer out from the pedestal.
B. If the ash drawer cover is not at a 90° angle with the ash drawer housing loosen the bottom adjustment
screws, position the ash drawer cover to a 90° angle, then tighten the screws.
C. To change the spacing between the ash drawer cover and pedestal, loosen the side adjustment
screws (both sides) and position to the desired space, then tighten the screws.
SIDE
ADJUSTMENT
SLOTS/SCREWS
BOTTOM
ADJUSTMENT
SCREWS
ASH
DRAWER
COVER
ASH DRAWER
HOUSING
DRAWER
DISCONNECT
LEVER
PEDESTAL
ASH DRAWER
HANDLE
SLOT OF ASH
DRAWER
ASH DRAWER
ASH PAN
NOTE: REFER TO THE ILLUSTRATION BELOW FOR HANDLE STORAGE