Napoleon Fireplaces GSS48ST - Manuel (Page 23)

www.napoleongrills.com
23
EN
LED Lights: Your appliance has been equipped with a LED (light) strip which is programmed with three
colour modes. Plug the LED power supply into a GFI protected electrical outlet.
Turn on the light switch located under the access panel and toggle the switch off and on to cycle through
to desired Mode.
Mode 1 - Simulated White.
Mode 2 - Continuous 2 colour shift. Takes 8-10 seconds to smoothly ramp up one colour to 100%, as the
other fades off from 100% to 0. Continually shifts in colour (17 seconds per colour, up and back down.)
Mode 3 - Freeze Mode Colour stops the colour shift on whichever colour it was on in Mode 2 at the time it
was turned off, does not continue to shift.
NOTE!
Switch off for 10 seconds to reset to beginning colour mode.
WARNING!
Glass embers may have sharp edges, wear safety glasses and gloves when handling.
Do not change or substitute the glass ember material provided with this appliance. If replacing, use
only replacement glass embers available from your local authorized dealer / distributor.
WARNING!
To avoid the possibility of burns, maintenance should be done only when the appli-
ance is cool. Avoid unprotected contact with hot surfaces. Ensure burner is turned off. Turn gas off at
source and disconnect the appliance before servicing. Clean the appliance in an area where cleaning
solutions will not harm decks, lawns, or patios. Do not use flammable, corrosive or abrasive cleaners.
Note: Stainless steel tends to oxidize or stain in the presence of chlorides and sulfides, particularly in
coastal areas and other harsh environments, such as the warm, highly humid atmosphere around pools
and hot tubs. These stains could be perceived as rust, but can be easily removed or prevented. To provide
stain prevention and removal, wash all stainless steel surfaces every 3-4 weeks or as often as required
with fresh water and/or stainless steel cleaner.
Control Panel: The control panel text is printed directly on the stainless steel and with proper maintenance
will remain dark and legible. To clean the panel, use only warm soapy water or stainless steel cleaner
available from your Napoleon dealer. Never apply abrasive cleaners on any stainless surfaces, especially
the printed portion of the control panel or the printing will gradually rub off.
Maintenance / Cleaning Instructions
WARNING!
Hose: Check for abrasions, melting, cuts, and cracks in the hose. If any of these
conditions exist, do not use the appliance. Have the part replaced by your Napoleon dealer or qualified
gas installer.
Cleaning Inside The Appliance: While washing your appliance, be sure to keep the area around the burner
and pilot assembly dry at all times.
WARNING!
If the gas control is exposed to water in any way, DO NOT try to use the appliance.
The gas control must be replaced.
AC Connector
AC
Transformer
120 vAC 12 vAC Threaded
Power
Connector
FLAG
CONNECTORS
Digital Control Unit for
LED Colour switching
MD6
Connector
MD6
Connector
Strip Light
Strip Light