Napoleon Fireplaces GSS48ST - Manuel (Page 21)

www.napoleongrills.com
21
EN
Lighting Instructions
WARNING!
Keep face and body away from burner area when lighting.
WARNING!
Ensure burner controls are in the off position. Slowly turn on the gas supply valve.
1. Press and hold electronic igniter button ( ).
2. Turn the burner control to the high position, press and hold in. When the burner
lights, release the electronic igniter button.
3. Continue to depress the burner control knob for 30 seconds and then release. If the
flame goes out, repeat the procedure.
4. Adjust the flame to the desired height with the burner control knob.
5. If the burner will not light with the electronic igniter, hold a lit long match or lit long
butane lighter to the ignition area of the burner and continue with step 2.
6. To shut down the burner turn the burner control knob clockwise to the off position.
Then turn the gas off at the source (propane cylinder valve or natural gas supply valve).
WARNING!
The propane cylinder is equipped with an excess flow device. Unless burners are turned
off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
If the burner does not light within 10 seconds, turn the valve off and wait 5 minutes for
any gas to dissipate before repeating the procedure.
If lighting the unit with a match, clip the match into the supplied lighting rod.
Open Cover
Lights Burner Control Igniter