Napoleon Fireplaces High Country 6000 - NZ6000 - Manuel (Page 44)

W415-0594 / E / 10.19.12
44
A. Remove the grill and filter by removing the 2 securing screws.
B. Remove the nut securing the blower bracket to the housing.
C. Lift the handles to pull the blower and bracket off of the stud.
D. Slide the bracket and blower out of the housing.
E. Disconnect the wire connector from the blower.
F. Remove the old blower from the bracket by removing the four
screws.
G. Secure the new blower to the existing bracket using the four
screws.
H. Slide the new blower/bracket assembly into the housing.
Ensure that the blower bracket slides into the clips at the back of
the housing on either side.
I. Push the assembly into the housing as far in as possible.
J. Secure the assembly to the housing using the nut removed in
step B.
K. Re-secure the grill by replacing the 2 securing screws.
BLOWER/BRACKET ASSEMBLY
HOUSING
CLIP
HANDLES
STUD
BRACKET
BLOWER
NUT
9.7 NZ64 BLOWER REPLACEMENT