Napoleon Fireplaces High Country 6000 - NZ6000 - Manuel (Page 32)

W415-0594 / E / 10.19.12
32
GRILLE
FILTER
ALLOW FOR
THICKNESS
OF FINISHING
MATERIAL AVERTISSEMENT
:
AIR COMBURANT SEULEMENT
WA RN IN G:
COMBUSTION AIR ONL Y
W ARNING: BLOWER
CONNECTION ONL
Y
AVERTISSEMENT
:
CONNEXION DE LA SOUFFLERIE
SEULEMENT
INST
ALL
THE KB35 AND BY-P
ASS
SWIT
CHES IN A CONVENIENT
LOCA
TION
6.11 NZ150-KT KIT
E. Connect the 6” liner to the appliance and blower collars. Secure using 3 screws on each end and seal
with caulking.
Liner supplied stretches to a maximum of 10’.
F. Insert the fi lter into the grill. Foam gasket ( 1 /
2
” weather stripping) between the grill and blower housing
is recommended, but not supplied.
The blower fi lter is washable.
G. The bottom lip of the grill latches over the bottom lip of the housing. Use two screws to secure the top
of the grill to the facing.
The circulation air inlet pipe must terminate outside of the
appliance enclosure to ensure proper air fl ow around the
fi rebox.
The 6" circulation air inlet pipe may be connected to either
the NZ64 blower kit or the NZ150-KT kit.
Avoid terminating higher than the bottom of the doors on the
appliance to prevent air fl ow reversal.
An optional opening is covered on the other side of the appli-
ance. If this location is preferred, switch the cover plate and
collar.
AVERTISSEMENT
:
AIR COMBURANT SEULEMENT
W ARNING:
COMBUSTION AIR ONL Y
INST
ALL
THE KB35 AND BY-P
ASS
SWIT
CHES IN A CONVENIENT
LOCA
TION
6.12 NSK6 OPTIONAL SCREEN KIT
Use the screen when you are in the room to enjoy the ambience of an open, wood crackling fi re.
Medium sized wood loads should be used to prevent logs from rolling against the screen.
Chimney action may not allow the screen to be used in some installations due to the resulting smoke spillage.
Opening the by-pass damper may help prevent smoke spillage. Wood will burn at a faster rate and heat out-
put will be less with the screen compared to the stove operation with the glass doors closed.