Napoleon Fireplaces Vittoria - GD19 - Manuel (Page 43)

43
W415-1004 / B / 08.10.12
10.1 CONTROL FUNCTIONS
MAIN
BURNER
SWITCH
NIGHT
LIGHT TM
SWITCH
FLAME
ADJUSTMENT
FAN
CONTROL
(OPTION)
MAIN BURNER SWITCH
This switch turns the Main Burner on and off.
FLAME ADJUSTMENT
Turn this knob clockwise or counter-clockwise to adjust the
main burner fl ame height.
NIGHT LIGHT TM SWITCH
This switch turns the Night Light TM on and off.
FAN CONTROL OPTION
If installed this switch will turn on and off the power to the
blower and control the fan speed. There is also a thermally
activated switch that will only let the blower come on once the
appliance has reached a comfortable temperature.
11.0 ADJUSTMENTS
11.1 PILOT INJECTOR AND ORIFICE REPLACEMENT
!
WARNING
THIS INSTALLATION SHOULD BE DONE BY A QUALIFIED INSTALLER AND SHALL BE IN
COMPLIANCE WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT
CAN1-B149 INSTALLATION CODE IN CANADA, OR THE CURRENT NATIONAL FUEL GAS CODE ANSI
Z223.1 IN THE UNITED STATES.
A. Turn off the electrical and gas supply to the appliance.
B. Remove the cast front, glass viewing door and log set.
C. Remove the 2 securing screws. Slide the burner assembly to the right and lift out.
D. Using a deep socket wrench, remove the main burner orifi ce. A back-up wrench
must be used on the manifold, located below the housing to ensure that the
aluminum tubing does not twist or kink. Replace the correct burner orifi ce using
pipe thread compound.
E. Loosen nut and replace with appropriate injector
F. Reinstall the burner ensuring that the Venturi tube fi ts over the orifi ce. NOTE:
Check and adjust, if necessary, the primary air to 1/16” for propane
and 1/32” for natural gas. Replace the screws.
G. Turn on the gas supply and check for gas leaks by brushing on a soap
and water solution.
DO NOT USE OPEN FLAME.
H. Replace the log set. Then light the pilot and main burner to ensure that
the gas lines have been purged.
I. Replace the glass viewing door and cast front. Turn on the electrical supply to
the appliance.
Purge all gas lines with the glass door removed. Assure that a continuous fl ow
is at the burner before re-installing the door.
BURNER
ASSEMBLY
ORIFICE
LOCATION