Napoleon Fireplaces Vittoria - GD19 - Manuel (Page 41)

41
W415-1004 / B / 08.10.12
9.0 OPTIONAL BLOWER INSTALLATION
!
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK.
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
VOID THE WARRANTY AND CERTIFICATION.
ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
CORD BENEATH THE APPLIANCE.
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
CONTACT WITH MOVING OR HOT OBJECTS.
51.5
THERMAL
DISK
ASSEMBLY
BLOWER
ASSEMBLY
SUPPORT
BRACKET
SEE-TH
RU
W
IN
D
O
W
CLIP
VARIABLE SPEED
SWITCH LOCATION CONTROL
PANEL
RED
BLACK
THERMAL SWITCH
VARIABLE SPEED SWITCH
BLOWER
WIRE
HARNESS
(included in GS66 kit)
WHITE
TO POWER SUPPLY
WHITE
GS66 WIRING DIAGRAM
VARIABLE
SPEED SWITCH
KNOB
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and
grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 Canadian
Electrical Code in Canada or the current ANSI/NFPA 70 National Electrical Code in the United States.
If an optional blower is to be used, the blower must be connected to the main power supply. Route a grounded
14 gauge 2-wire power cable to the junction box and ground. At the point where the cable enters the junction
box, a conduit connector must be provided.
A. Remove the two screws that secure the control panel to the front of
the unit.
B. Connect the black and red wires of the wire harness to the prongs
on the blower.
C. Connect the white and black wires of
the wire harness to the prongs on the
thermodisc.
D. Place the thermal switch assembly
onto the stud located at the lower left
of the fi rebox and behind the support
bracket.
E. Connect the wiring for the variable
speed switch.
F. Insert the blower assembly into the
left side under the fi rebox, slide into
the clip and place onto the same stud
used for the thermal switch assembly.
Secure with the lock washer and wing
nut supplied. Ensure that the blower
does not touch the base of the fi rebox,
any wiring or controls. Ensure that the thermal switch is touching
the wall of the fi rebox.
HINT: Rest the thermal disk assembly forward against the
support bracket.
G. Place the variable speed switch into position and secure with the
pal nut supplied. Reinstall the control panel and install the variable
speed switch knob.
NOTE: Plug into the receptacle on the right side of the unit.