Sony CSS-HD1 - Manuel (Page 11)

11-GB
To use your Cyber-shot Station abroad
- Power sources
You can use the Cyber-shot Station and the AC
Adaptor (supplied) in any country or region where
the power supply is within 100 V to 240 V AC
50/60 Hz.
Use a commercially available AC plug adaptor,
if necessary, depending on the design of the wall
outlet (wall socket).
AC plug adaptor
(not supplied)
Do not use an electronic transformer (travel
converter), as this may cause a malfunction.
Preparing the remote control
Notes on the remote control
The remote control is powered by a button type
lithium battery (CR2025) installed at the factory.
An insulation sheet is inserted to avoid the battery
exhaustion. Remove the insulation sheet before
using the remote control for the first time.
Insulation sheet
Point the remote sensor of the Cyber-shot Station
away from strong light sources such as direct
sunlight or overhead lightings. Otherwise, the
remote control may not function properly.
The remote control range is less than five meters
(for indoor use). Point the remote control at the
remote sensor of the Cyber-shot Station. Try
adjusting the angle of the remote control if you
cannot operate the Cyber-shot Station.



Set up
Preparing the Cyber-shot Station
1
Set the MODEL SELECT switch.
See the table below and set the MODEL
SELECT switch to match with your camera.
MODEL SELECT
switch ( , )
DSC-W200, DSC-W90, DSC-W85,
DSC-W80
DSC-T100, DSC-T25, DSC-T20

Connect the AC Adaptor to the DC IN jack
of the Cyber-shot Station.
To a wall
outlet
(wall socket)
Cyber-shot
Station
DC plug
AC Adaptor
AC Power cord
(mains lead)