Sony CSS-HD1 - Manuel (Page 15)

1-GB
Troubleshooting
If any problems occur with your products, refer to the following solutions.
If the problem persists, contact your Sony dealer.
Symptom Cause/Solution
Unable to charge the battery pack (when
the CHARGE lamp fails to light)
The camera is turned on.
Turn the camera off.
The AC Adaptor is disconnected.
Connect the AC Adaptor properly.
The camera is not placed on the Cyber-shot Station correctly.
Place the camera correctly.
The battery pack is not installed correctly.
Install the battery pack correctly.
The battery pack is completely charged.
The battery pack installed into the camera is inapplicable.
Install the battery pack compatible with your camera.











The CHARGE lamp blinks fast, or blinks
for more than 10 seconds
The battery pack installed into the camera is inapplicable.
Install the battery pack compatible with your camera.
The connection is not correct.
Remove the camera from the Cyber-shot Station and
reconnect the AC Adaptor. After the CHARGE lamp goes
off, place the camera on the Cyber-shot Station.




Unable to turn on the camera, or
it suddenly gets turned off
The camera is not placed on the Cyber-shot Station correctly.
Place the camera correctly.
The AC Adaptor is disconnected.
Connect the AC Adaptor properly.




The images/sounds cannot be played
back on a TV
The connection is not correct.
The audio cannot be output when only the Component
video cable is connected. Connect the AV connecting
cable to the audio jack correspond to the component
video jack.
The Component video out setting of the camera is not correct.
Refer to the operating instructions supplied with the
camera, and set the [COMPONENT] setting correctly.




The images cannot be output via the AV
connecting cable
The Component video cable is connected to the
Cyber-shot Station and the TV.
Unplug the Component video cable from the Cyber-shot
Station.


Buttons on the remote control do
not work, and no operations can be
performed
The AC Adaptor is disconnected.
Connect the AC Adaptor properly.
The battery in the remote control is dead.
Replace the battery with a new one.




Unable to attach the camera on the
Cyber-shot Station
The MODEL SELECT switch is not set to its designated
position.
Set the MODEL SELECT switch to the designated
position.

