Panasonic AG-DTL1 - Manuel (Page 46)

46
Menu page P6
[TAPE REMAIN] P6
LEVEL OFF
BUZZER OFF
[REC REVIEW]
AUTO OFF
ERROR BUZZER OFF
[ERROR WARN BUZZER]
MODE OFF
[REC WARNING]
REC LOSS BUZZER OFF
TAPE REMAIN screen
Menu item Description of function
LEVEL For setting at what point REMAIN is to flash on the display tube and
the remaining tape warning is to be displayed when the tape-end
position is about to be reached. (When using a 120-minute tape)
The REMAIN flashing is released when any button is pressed.
OFF : The remaining tape warning is not displayed.
2% : The warning is displayed when the remaining tape amount is
less than approximately 2%.
10% : The warning is displayed when the remaining tape amount is
less than approximately 10%.
20% : The warning is displayed when the remaining tape amount is
less than approximately 20%.
30% : The warning is displayed when the remaining tape amount is
less than approximately 30%.
BUZZER For setting whether the buzzer is to sound when the tape-end
position is about to be reached. The buzzer is stopped when any
button is pressed.
ON : The buzzer sounds at the position which was set for the
LEVEL item.
OFF : The buzzer does not sound.
The underlining indicates the factory mode setting.
REC REVIEW screen
Menu item Description of function
AUTO For setting automatic REC REVIEW.
(This function plays back the recording after recording for a specific
time in order to detect whether the proper video level is being
maintained during recording.)
ON : REC REVIEW is performed automatically.
If the level detected is found to be unacceptable, the tape is
loaded and unloaded three times, and REC REVIEW is
automatically performed again. If it is still unacceptable even
after this, recording is performed.
OFF : REC REVIEW is not performed automatically.
ERROR BUZZER For setting whether the buzzer is to sound when it is discovered by
REC REVIEW that the proper video level was not maintained.
ON : The buzzer sounds. It is stopped when any button is pressed.
OFF : The buzzer does not sound.
The underlining indicates the factory mode setting.
Setting menus