Rs-232c, Time lapse control commands – Panasonic AG-DTL1 Manuel d'utilisation

Page 75

Advertising
background image

75

RS-232C

$

Time lapse control commands

These commands are not acknowledged while a search control command is being processed.

Data transmitted by PC

Data returned from unit in response

Description of command

[STX] LAD:m [ETX]

Parameter
m = 0: 30 seconds

1: 1 minute
2: 1 minute and 30 seconds
3: 2 minutes
4: 3 minutes
5: 6 minutes
6: 10 minutes
7: CONTINUE:

Recording continues until
the tape-end.

8: MANUAL:

Recording only while an
alarm signal is input.

[STX] LAD [ETX]

Sets the time during which alarm recording or sensor
recording is to be performed.

[STX] LAI:m [ETX]

Parameter
m = S: STOP

Stop mode established at
tape-end position.

C: CONTINUE

Alarm signal input is
ignored.

[STX] LAI [ETX]

Sets the operation mode that is to be established when an
alarm signal has been input at the tape-end position.

[STX] LBM:m [ETX]

Parameter
m = N: ON

Output of the black burst
signal.

F: OFF

No output of the black burst
signal.

[STX] LBM [ETX]

Sets the processing to be performed for the black burst
signal when the video signals to be output from the video
signal output connectors are switched.

[STX] LBP:m [ETX]

Parameter
m = ¢: Video signals of all the

cameras are output.

0: Camera 1
1: Camera 2
2: Camera 3
3: Camera 4
4: Camera 5
5: Camera 6
6: Camera 7
7: Camera 8
8: Camera 9
9: Camera 10
A: Camera 11
B: Camera 12
C: Camera 13
D: Camera 14
E: Camera 15
F: Camera 16

[STX] LBP [ETX]

Prevents the video signals of the camera designated by the
parameter from being output from the VIDEO OUT
connector.

[STX] LAR [ETX]

[STX] LAR [ETX]

Deletes the ALARM RECALL data.

Advertising