weber Performer 22 Inch Performer® Deluxe Charcoal Grill Assembly Guide - Manuel (Page 27)

WWW.WEBER.COM 27
MAINTENANCE
ELECTRONIC IGNITION INSPECTION
If the Electronic Ignition System fails to ignite, be sure there is gas flow by attempting to
match light your burners. Refer to “MANUAL LIGHTING”. If match lighting is successful,
the problem lies is the electronic ignition.
m WARNING: Gas control and supply valve should be in the OFF
position.
• Verify that the AAA battery (alkaline only) is in good condition and installed correctly
(1). Some batteries have a plastic protective wrap around them. This plastic must
be removed. Do not confuse this plastic with the battery label.
• Check that both the white (2) and black (3) ignition wires are attached properly.
• Check that the Electronic Ignition button is working by listening and looking for
sparks at burner.
• Check to see if the igniter is loose in the frame. Tighten if necessary; see step
“Install” for the correct procedure.
Replace Battery If Necessary
AAA alkaline battery only.
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site. Log onto
www.weber.com. ◆
PERIODIC QUICK CLEANING
We recommend that you periodically brush the outside of the burner slots with a wire
brush and clean the burner tube through the combustion air vent with the matchstick
holder we have provided.
This can be done by locating the burner combustion air vent (1) underneath the bowl
bracket and inserting the tool through each combustion air vent, rotating the tool. Be
careful when inserting the matchstick holder not to damage the igniter electrode.
m CAUTION: It is important to increase the frequency of this
cleaning procedure during the spring and summer months.
1
4
5
6
BURNER FLAME PATTERN
The burner has been factory set for the correct air and gas mixture. The correct flame
pattern should have yellowish tips (4) dark blue in the middle (5), and light blue at the
burner tube (6). If the flames do not appear as shown, or if “popping” noises occur,
follow the burner cleaning procedures.
3
2