Curtis RLC4033A - Manuel (Page 6)

ACCESSORIES
Please check and identify the supplied accessories.
............................................................................................................ .........
................................................................................................................
...........................................................................................................
...................................................................................................................
GETTING STARTED
USING THE REMOTE CONTROL
TO INSTALL THE BATTERIES
BATTERY REPLACEMENT
CAUTION
1
. Open the battery door. 2. Insert 2 "AA" batteries
.
: Danger of explosion if battery is incorrectly replaced.
NOTES
WARNING :
3
x 2
x 1
x 1
x 1
x 1 Remote control .................................................................................................................. Remote control
Battery(AA)
Warranty Card
Instruction Manual
Power Cord
·
Point the remote control at the remote sensor located on the unit.
·
When there is a strong ambient light source, the performance of the infrared remote sensor
·
may be degraded, causing unreliable operation.
·
The recommended effective distance for remote operation is about 16 feet (5 meters).
When the batteries become weak, the operating distance of the remote control is greatly
reduced and you will need to replace the batteries.
·
If the remote control is not going to be used for a long time, remove the batteries to avoid
damage caused by battery leakage corrosion.
·
Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or
rechargeable (NICKEL-CADMIUM) batteries.
·
Always remove batteries as soon as they become weak.
·
Weak batteries can leak and severely damage the remote control.
Do not dispose batteries in a fire. Batteries may explode or leak.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Base stand and 6 screws ........................................................................................... x 1
Screw driver ................................................................................................................ x 1
Base cover ................................................................................................................... x 1