GE ZGU384NSMSS - Manuel (Page 7)

Installation Preparation
DIMENSIONS AND CLEARANCES
1. Overall cooktop dimensions:
^-------------30-3/4" ^ I
21-5/8"
deep at
center
3-3/4"
2. Use a 30" or wider base cabinet.
• Cut the opening in the countertop. To ensure
accuracy, it is best to make a template for the
opening. Make sure the sides of the opening are
parallel and the rear and front cuts ore exactly
perpendicular to the sides.
• Observe all minimum clearances.
For island installation, maintain 2-1/2" min. from
cutout to the front, bock, and side edges of
countertop.
12" min.
from cutout
to side wall
12
"
min.
from
cutout
to side
wall
^-7/8" min.
tom cutout
to rear
yertical
:ombustibles
2-1/2" min.
from cutout
to front of
countertop
30" or wider
cabinet base
recommended
3. Moke sure the wall coverings, countertop and
cabinets around the cooktop con withstand heat
(up to 200°F) generated by the cooktop.
13" max.
7/15"-,
DRAWER
NOTE: Allow 7/16" minimum
vertical clearance from the
cooktop bottom (or 4-9/16"
minimum depth from the
countertop) to any combustible
surfaces, such as a cabinet
drawer.
For island installation, maintain
2-1/2 in. minimum from
cutout to front and back edge
of countertop. Maintain 3 in.
minimum from cutout to side
edges of countertop.
4. For Americans with Disabilities Act (ADA) Forward
Approach Installation Only:
- 5”-,
Allow 5" minimum
depth between the
countertop and an
enclosure.
C
NOTE:Jhe enclosure must be made of wood
material. Also, an access panel is required for the
electrical outlet, pressure regulator, shut-off valve,
hold-down brackets, and service.