Safety information, Electrical requirements – GE ZGU384NSMSS Manuel d'utilisation
Page 3
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Safety Information
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the proper
voltage and frequency and connected to on individual,
properly grounded branch circuit, protected by a
circuit breaker or fuse having amperage os noted on
the rating plate.
We recommend you hove the electrical wiring and
hookup of your cooktop connected by a qualified
electrician. After installation, have the electrician show
you where your main cooktop disconnect is located.
Check with your local utilities for electrical codes
which apply in your area. Failure to wire your
cooktop according to governing codes could
result in a hazardous condition. If there are no codes,
your cooktop must be wired and fused to meet the
requirements of the National Electrical Code, ANSI/
NFPA No. 70—Latest Edition. You can
get a copy by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02259
In Canada, your cooktop must be wired and
fused to meet the requirements of the Canadian
Electrical Code.
CONTENTS
Installation Preparation
Installation Instructions for Natural
Models Available.................................. .......4
to LP Gas Conversion
Parts Included...................................... . . . . 4
Tools You Will Need.............................. . . . 1 5
Materials You May Need...................... . . . . 4
Adjusting the Regulator........................ . . . 1 5
Tools You Will Need............................. . . . . 4
Changing the Orifices........................... 15, 15
Advance Planning and
Installation Options.............................. . . . . 5
Adjusting Burner Flames...................... . . . 1 5
Pre-Installation Checklist..................... . . . . 5
Installation Instructions for LP
Dimensions and Clearances................. . . . . 7
to Natural Gas Conversion
Gas Supply Locations............................ . . . . 8
Tools You Will Need.............................. . . . 1 7
Adjusting the Regulator........................ . . . 1 7
Installation Instructions
Changing the Orifices........................... 17, 18
Step-by-Step Instructions..................... . 9-11
Adjusting Burner Flames...................... . . . 1 8
Operation Checklist.............................. . . . 1 1
Installation Options
Installation With a Downdraft Vent... . . . 1 2
Installation Over a Warming Drawer. . . . 1 3
Installation Over a Single Oven............ . . . 1 4