GE ZGU384NSMSS - Manuel (Page 15)

Installation
Instructions
Convert Natural Gas Model ZGU384NSMSS
to LP Gas Operation
If sold outside the U.S. and Canada:
AWARNING:
If you wish to use this product
with Liquefied Petroleum (LP) gas containing greater
than 10% butane, you must purchase the butane
conversion kit #WB28T10238. To order, please call
1.888.664.8403 or 1.787.276.4051.
SAFETY INFORMATION
The pressure regulator and burner orifices ore set for
natural gas operation.
To convert this cooktop from natural gas operation to
LP operation, the regulator and burner orifices must be
converted. LP burner orifices are attached to the regulator
along with separate LP conversion instructions.
A CAUTION
— The cooktop, as shipped from
the factory, is set for use with its intended gas. If you
wish to use your cooktop with the alternate gas, you
must first replace the orifices and convert the pressure
regulator.
AWARNING
— This conversion must be
performed by a qualified installer or gas supplier in
accordance with the manufacturer's instructions and all
codes and requirements of the authority having
jurisdiction. Failure to follow instructions could result in
serious injury or property damage. The qualified agency
performing this work assumes responsibility for the
conversion.
A CAUTION
— The following adjustments must
be made before turning on the burner. Failure to do so
could result in serious injury. Be sure pressure regulator
has been converted as described in Step 1.
TOOLS YOU WILL NEED
FOR CONVERSION
Crescent wrench
7mm nutdriver
Safety glasses
Small flat-head
screwdriver
(2 to 2.4 mm or 3/32"
tip size, 60 mm or
2-3/8"long)
1 ADJUST THE REGULATOR
A. Disconnect all electrical power, at the main circuit
breaker or fuse box.
B. Shut off the gas supply to the cooktop by closing the
manual shut-off valve.
C. Adjust the pressure regulator by the following
Instructions:
• Unscrew the cap.
• Carefully look at the spring retainer to locate the NAT
or LP position.
• Turn the spring retainer over by rotating It 90 deg., pull It
from the cap, turn the spring retainer over so that LP Is
showing. Insert It back Into the cap, and then rotate It 90
deg. Into position.
• Screw the cap back onto the regulator and tighten.
Gasket
Spring
Retainer
NAT.
Position
L.P./Propane
___, Position
Pressure Regulator
15
2 CHANGE BURNER ORIFICES
Burner
head
INSTALLATION TIP: First remove all
orifices and then start replacing them.
This will help to prevent the possibility
that some may not be replaced.
A. Remove the burner grates,
burner caps and burner heads.
B. Use pliers to hold the orifice
In position during Initial thread
engagement or final removal to
avoid dropping the orifice In the
cooktop. Use the 7mm nut Spark Igniter
driver to tighten or loosen.
There are two orifices per
burner.
The main orifice Is located low
In the center of the burner,
while the simmer orifice Is
located higher beside the
center of the burner.
Burner cap
Burner
base
Simmer
orifice
Main
orifice