Panasonic DVD-ROM CF-VDD283 - Manuel (Page 8)

Software Preparation
(first time only)
Using the DVD-ROM Drive Pack in the MS-DOS Mode
To use the DVD-ROM Drive Pack in the MS-DOS mode, configure the drive following the
steps below after performing the preparations (([^ page 6, “NOTE”). If the steps listed
below' are performed without completing the preparations first, the drive will not op­
erate properly.
1
Click the [Sturt] button then select [Shut Down],
2
Select [Restart in MS-DOS mode] and click [OK],
3 Open the “CONFIG.SYS” file for editing by issuing the following commands:
cd \C Enter )
edit config.sys i Enter )
4 Move the cursor to the line containing “OAKCDROM.SYS” and delete the characters
“rem” at the beginning of the line. (Deleting “rem” causes the item to become valid.)
DEVlCEHIGH=C:\WlNDOWS\COMMAND\OAKCDROM.SYS /DiMSCDOOO
(if this line is missing, add it.)
5
Press CM) +CE) , then CD to save the file. Then press (Alt ) +CE), thenC X ) to
exit the Edit program.
6 Follow the same steps to edit the “AUTOEXEC.BAT” file,
edit autoexec.bat C Enter )
7
Move the cursor to the line containing “MSCDEX.EXE” and delete the characters “rem”
at the beginning of the line. (Deleting “rem” causes the item to become valid.)
LOADHIGH C:\WlNDOWS\COMMANDVMSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
Ô
Press CMD +CZ) , then CD to save the file. Then press
C M )
, then to
exit the Edit program.
9 Restart the computer.