Panasonic WV-CM2080 - Manuel (Page 4)

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
Front View
® Power Button (POWER ON/OFF)
This button turns the power of the nnonitor on and off.
® Power Indicator
Is on when the power of the monitor is turned on, also
in standby mode.
On: Green light
Standby: Orange light
(3) standby Button (STANDBY)
Pressing this button toggles the display mode on the
monitor screen as shown below.
On: Normal display
Standby (Mode 1): Lower display brightness
Standby (Mode 2): No display (blackout)
® Input Selection Button (INPUT SELECT)
Selects input in the sequence shown below.
r
VIDEO IN A^VIDEO IN B-* S-VIDEO IN
I]
(D Menu Button (MENU)
Pressing this button opens the Display Setting menu for
changing the monitor’s display settings.
Pressing this button for 5 seconds or more opens the
COMMUNICATION SETUP menu,
© Direction Button ( T , A )
These buttons move the cursor to the item parameters
in the Display Setting and Setup menus.
A: Up
T: Down
® Decrement/Increment Button (AUDIO [3, 0)
Press these buttons to increase or decrease the audio
volume.
These buttons also select the item parameter or level in
the Display Setting and Setup menu.
® Focus Control (FOCUS)
This control adjusts the screen focus.
® Screen Control
This control is preset at the factory.
® Data Ports (DATA)
These ports are used to exchange control data with the
System Controller in Panasonic Security Data mode.
® Data Termination Selector (TERMINATION ON/OFF)
This selector is used to enable termination of the moni­
tor's data port.
® Standby Control Terminal (STANDBY ON/STANDBY
OFF/G)
This terminal accepts input from an outboard device to
control the standby mode.
It operates as follows:
STANDBY ON: Establishes the specified standby
mode.
STANDBY OFF: Releases standby mode (normal dis­
play).
® Audio Input Connectors (AUDIO IN A/B)
For audio input from an outboard device
® Audio Output Connector (AUDIO OUT A/B)
The audio input signal connected to the Audio Input
Connector is looped through to this connector.