Operating procedures (with the system controller) – Panasonic WV-CM2080 Manuel d'utilisation
Page 13
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
OPERATING PROCEDURES (with the System Controller)
For the following procedure, the WV-CM2080 needs to be set up first from the Setup menu.
The WV-CM2080 can be controlled with the specified System Controller.
Given below is an example. For further details refer to the Operating Instructions supplied with the System Controller.
1. Select a Unit Address number by pressing the Numeric buttons, then press the UNIT button.
2. To select the input to be displayed, select a specified CAM NO. (input number assigned) by pressing the Numeric but
tons, then press the CAM (SET) button.
3. To open the Display Setting menu, press the SETUP button for two seconds or more.
4. Move the cursor to the item parameter by moving the joystick up or down, then select the item parameter by moving the
joystick to the left or right,
5. Pressing the CAM (SET) button will switch to the level indicator display, then pressing the MON (ESC) button will return to
the menu display.
6. To close the menu, press the SETUP button for two seconds or more
7. To activate the assigned function, select an assigned number by pressing the Numeric button, then press the FUNCTIONi
button.
Note: For function numbers refer to the Appendix on page 15.
13