Troubleshooting, The on/standby indicator keeps flashing, Temperature" is displayed – Sony CPJ-D500 Manuel d'utilisation
Page 28: Fan" is displayed, The unit does not turn on, No picture is projected, The picture is dark, The picture is unclear, The picture is distorted
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Troubleshooting
If you run into any problems using the unit, use the
following table to troubleshoot the problem.
If the problem persists, consult your nearest Sony
dealer.
The ON/STANDBY indicator keeps flashing.
• Disconnect the power cord. Wait for more than 3
seconds and connect again.
"TEMPERATURE" is displayed.
• Change or clean the filter sponge (p. 24).
• Clean the filter holes so that they are not blocked.
• If the above remedy does not work, consult your
dealer.
"FAN" is displayed.
• Consult your dealer.
The unit does not turn on.
• Check the connection (p. 7 - 1 1 ) .
• Close the bulb cover properly.
No picture is projected.
• Check the connection (p. 7 - 1 1 ) .
• Select the input signal (p. 14).
• Select the RGB mode when using with a PC (p. 14).
• Check the connected source equipment.
• Remove the lens cap.
No picture is projected because the POWER button
is pressed while the LAMP indicator is flashing
• Disconnect the power cord and wait for more than 3
minutes. Then connect the power cord and turn on
the power.
The picture is dark.
• Adjust the picture (p. 17 - 23).
• Replace the bulb with a new one (p. 25).
The picture is unclear.
• Adjust the focus (p. 15).
• Synchronize the RGB signal (p. 19).
The picture is distorted
• Place the unit so that the lens is perpendicular to the
projected plane.
• Adjust the angle with the stand (p. 12)
28-EN Troubleshooting