Projecting, Turning on the projector – Sony CPJ-D500 Manuel d'utilisation
Page 12
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Projecting
If the bulb does not
light up
If you press POWER
again just after turning
it off, the bulb wilbnot
light up. This is because
of the characteristics of
the bulb and is not a
malfunction. In this
case, wait for a while
and press POWER
again. The bulb will
light up.
Notes
• Wait until the
projector is warmed
up. It will take about
one minute until the
projected plane
appears.
• Do not press POWER
while the LAMP
indicator is flashing.
Doing so will cause
malfunction of the
unit.
Turning on the projector
1
Press POWER of the control panel.
The ON/STANDBY indicator turns green. The
LAMP indicator starts flashing.
The bulb lights up and the projected plane appears.
2
If necessary, adjust the position of the projected
plane using the stand.
® Unlock the stand.
@ Adjust the position.
(MS
@ Lock the stand securely so that the stand does
not collapse.
You can adjust the horizontal balance by
turning the spacer.
Spacer
12-EN Projecting