Changing the bulb, Use only the sony xb-cpj1mh lamp unit for – Sony CPJ-D500 Manuel d'utilisation
Page 25
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Notes
• Do not touch the bulb
immediately after use
as it will be very hot.
• Avoid touching the
surface of the new
bulb and the inside of
the reflector. Keep
them clean to ensure
the bulb efficiency.
WARNING
Do not touch the lens
and connectors when
changing the bulb to
prevent burning or
electrical shock.
Changing the bulb
The brightness of the bulb becomes about half after
about 2000 hours of use.
If theprojected picture is dark, change the bulb.
Use only the
Sony XB-CPJ1MH Lamp Unit
for
replacement.
1
Turn off the power and disconnect the power cord.
2
Wait until the bulb has cooled down (about 30
minutes).
3
Loosen the screw of the bulb cover using a coin and
remove the bulb cover.
4
Remove the screw securing the bulb unit using a
screwdriver (not supplied), and pull out the bulb
unit.
5
Install the new bulb unit and secure it with the
screw.
Maintenance
25-EN