Tweco 20 O2 Auto-Cut - Manuel (Page 28)

Manual No. 0-4816 Auto-Cut 200
2
3-4 INSTALLATION
3.04 Lift the Power Supply
WARNINGS
Do not touch live electrical parts.
Disconnect input power conductors from de-energized supply line before moving unit.
FALLING EQUIPMENT can cause serious personal injury and equipment damage.
Use all four lifting eyes when using lifting straps to lift the power supply.
Use a forklift, crane, or hoist to lift the unit off the shipping pallet as shown. Keep the power supply steady and
vertical. Do not lift it any further than necessary to clear the shipping pallet.
Art # A-04796
Set the power supply on a solid, level surface. The installer may fasten the power supply to the floor or a
supporting fixture with hardware passing through the horizontal parts of the power supply feet.