Garland GD SERIES GAS COUNTER UNITS - Manuel (Page 4)

Part # 4519762 (12/07) Page 4
PRE INSTALLATION
Damage Check
Damage check: Check carton or crate for possible damage
incurred in shipping. After carefully uncrating, check for
“concealed” damage. Report any damage immediately to
your carrier.
Rating Plate
All burner input ratings are shown on the serial, rating plate
of each unit and are readily visible by opening the enameled
door located below the control panel.
The correct type of gas for which the unit was manufactured
is noted on the rating plate, and this type of gas must be
used.
When corresponding with the factory or your local
authorized factory service center regarding service problems
or replacement parts, be sure to refer to the particular unit
by the correct model number (including the prefix and suffix
letters and numbers) and the warranty serial number. The
rating plate affixed to the unit contains this information.
We suggest installation, maintenance and repairs should be
performed by your local authorized service agency listed in
your information manual pamphlet.
In the event you have any questions concerning the
installation, use, care or service of the product, write or call
our Product Service Department.
This product must be installed by professional personnel as
specified. Garland/U.S. Range products are not approved or
authorized for home or residential use, but are intended for
commercial applications only. Garland / U.S. Range will not
provide service, warranty, maintenance or support of any
kind other than in commercial applications.
SPECIFICATIONS
MODEL NUMBER
MANIFOLD
INLET SIZE
OPERATING PRESSURE
“WC
INPUT
BTU/H
NATURAL PROPANE
GD-152H(J)(FF), GD-302H(J)(FF), GD-304H(J)(FF) 3/4” 4.0 10.0 14,800
GD-15F(J) 1/2” 4.2 9.0 45,000
GD-15G(J)(FF), GD-15GTH(J), GD-24G(J)(FF),
GD-24GTH(J), GD-36G(J)(FF), GD-36GTH(J)
3/4” 4.0 10.0 20,000
GD-18RB(J)(FF), GD-24RB(J)(FF),
GD-30RB(J)(FF), GD-36RB(J)(FF)
3/4” 4.0 10.0 15,000