L.B. White 400-650K Tradesman - Manuel (Page 8)

FFiigguurree 33 –– CCoom mppoonneennttss
DIMENSIONS & ASSEMBLY (cont.)
ASSEMBLY FOR CP400CK
TOOLS REQUIRED
• Medium Phillips screwdriver
• Adjustable wrench,
ASSEMBLING WHEEL & HANDLE
2. Slide one axle bushing on to each side of the axle.
Slide one wheel on to each side of the axle.
1. Slide threaded axle through the rear section of the
wheel support frame.
3. Attach one cap nut on to each side of the threaded
axle and tighten well
4. Place heater on wheel support frame.
Make sure air inlet end (rear) of heater is over
wheels. Align the holes on fuel tank flange.
Insert screws(L) through handles (front and Rear),
fuel tank flange, and wheel support frame.
Insert screws(S) through rear handle,
fuel tank flange, and washer(S) as shown in
figure 4 and attach nut finger tight after each
screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
6. Align the hole on the rear handle with the
mounting hole on the cord wrap.
7. Insert screws through cord wrap, rear handle as
shown in Figure 4 and attach nut finger tight
after each screw is inserted.
8. After all screws are inserted, tighten nuts firmly.
CAUTION
Risk of fire or explosion
-
Do not operate heater without support frame fully
assembled to tank.
FFiigguurree 44 –– W Whheeeell aanndd H Haannddllee AAsssseem mbbllyy
48
Front Handle
Rear Handle
Threaded Axle Wheel Support Frame
Wheels Cord Wraps
Screw (L) Screw (S)
Bushing Washers Cap Nuts Cap Nuts(S)
Nut
Screw (L)
Fuel Tank Flange
Handle
Wheel Support Frame
Wheel
Cap Nut (L)
Cap Nut (S)
Bushing
Nut Air Inlet
Washer
Threaded Axle
Screw (S)
Screw (S)
Cord Wrap