Putting the batteries in the remote control, Using the remote control, Controls and displays 03 – Pioneer HTP-710 Manuel d'utilisation

Page 50

Advertising
background image

Controls and displays

03

50

En

Putting the batteries in the remote
control

CAUTION

Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe
the following:

• Don’t mix new and old batteries together.

• Don’t use different kinds of battery

together — although they may look similar,
different batteries may have different
voltages.

• Make sure that the plus and minus ends of

each battery match the indications in the
battery compartment.

• Remove batteries from equipment that

isn’t going to be used for a month or more.

• When disposing of used batteries, please

comply with governmental regulations or
environmental public instruction’s rules
that apply in your country/area.

• Do not use or store batteries in direct

sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.

Using the remote control

Please keep in mind the following when using
the remote control:

• Make sure that there are no obstacles

between the remote and the remote sensor
on the unit.

• Remote operation may become unreliable

if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.

• Remote controllers for different devices

can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.

• Replace the batteries when you notice a fall

off in the operating range of the remote.

• Use within the operating range in front of

the remote control sensor on the unit, as
shown.

30°

30°

7 m

HTP-710_VYXCN_En.book 50 ページ 2010年8月23日 月曜日 午後6時47分

Advertising
Ce manuel est liée aux produits suivants: