Pioneer HTP-710 - Manuel (Page 43)

Connecting up 02
43
En
English
Deutsch
Italiano
Español
Français
Nederlands
Use the PRE OUT outputs to
connect the surround back
speakers
Connect the PRE OUT outputs of the system
and additional amplifier to add a surround
back speaker.
• You can use the additional amplifier on the
surround back channel pre-outs for a
single speaker as well. In this case plug the
amplifier into the left (
L (Single)) terminal
only.
Plugging in the system
Only plug in after you have connected all your
components to this system including the
speakers.
1 Plug the supplied power cord into the AC
IN socket on the back of the system.
2 Plug the other end into a power outlet.
CAUTION
• Handle the power cord by the plug part. Do
not pull out the plug by tugging the cord,
and never touch the power cord when your
hands are wet, as this could cause a short
circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on
the power cord or pinch the cord in any
other way. Never make a knot in the cord or
tie it with other cables. The power cords
should be routed so that they are not likely
to be stepped on. A damaged power cord
can cause a fire or give you an electric
shock. Check the power cord once in a
while. If you find it damaged, ask your
nearest Pioneer authorized independent
service company for a replacement.
• Do not use any power cord other than the
one supplied with this unit.
• Do not use the supplied power cord for any
purpose other than that described above.
• The system should be disconnected by
removing the mains plug from the wall
socket when not in regular use, e.g., when
on vacation.
1 2
ANALOG R L
AUDIO IN
Surround back
channel amplifier
Surround back speakers
SBL SBR
HTP-710_VYXCN_En.book 43 ページ ２０１０年８月２３日 月曜日 午後６時４７分