Pioneer HTP-710 - Manuel (Page 30)

Speaker Setup (HTP-SB510) 01
30
En
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Do not connect any speakers other than
those supplied to this system.
• Do not connect the supplied speaker to any
amplifier other than the one supplied with
this system. Connection to any other
amplifier may result in malfunction or fire.
• After connecting the plugs, pull lightly on
the cables to make sure that the ends of
the cables are securely connected to the
terminals. Poor connections can create
noise and interruptions on the sound.
• If the cable’s wires happen to be pushed
out of the terminals, allowing the wires to
come into contact with each other, it
places an excessive additional load on the
amp. This may cause the amp to stop
functioning, and may even damage the
amp.
Wall mounting the speaker
The speaker have the mounting holes which
can be used to mount the speaker on the wall.
Before mounting
• Remember that the speaker system is
heavy and that its weight could cause the
screws to work loose, or the wall material to
fail to support it, resulting in the speaker
falling. Make sure that the wall you intend
to mount the speaker on is strong enough
to support them. Do not mount on plywood
or soft surface walls.
• Mounting screws are not supplied. Use
screws suitable for the wall material and
support the weight of the speaker.
CAUTION
• If you are unsure of the qualities and
strength of the wall, consult a professional
for advice.
• Pioneer is not responsible for any
accidents or damage that result from
improper installation.
• When mounting the speaker on a wall,
install it so that it is parallel to the floor.
• When mounting the speaker on a wall, do
not attach the accessory speaker stands.
5 mm
10 mm
Mounting screw
(not supplied)
4 mm to 5 mm
460 mm
HTP-710_VYXCN_En.book 30 ページ ２０１０年８月２３日 月曜日 午後６時４７分