Pioneer HTP-710 - Manuel (Page 29)

Speaker Setup (HTP-SB510) 01
29
En
English
Deutsch
Italiano
Español
Français
Nederlands
If you decide not to use the speaker stands, use
the supplied adhesive to attach four small pads
to the base of the speaker.
2 Attach the speaker stand bases to the
speaker.
Attach both right and left speaker stands to the
rear of the speaker. The height of the speaker
stands can be adjusted in two levels; select the
height you prefer, and fix in position.
CAUTION
• Be careful not to tighten screws excessively.
• If excessive force is used to tighten screws,
the threads of screw may be damaged. Use
a middle-sized manual screwdriver during
assembly.
• Do not use power screwdrivers or oversized
screwdrivers that may exert excessive force
on the screws.
• Confirm that no foreign matter is stuck to
the stand or the speaker during assembly.
• If the unit is assembled with foreign matter
stuck between the stand and the speaker
the unit may not be assembled securely,
resulting in tipping or falling.
3 Connect each speaker.
Connect the wires to the speaker.
The rear of the speaker has channel terminals
(Right/Center/Left), together with color-coded
labels.
Front left: White
Front right: Red
Center: Green
Match the color-coded wire with the color
indicator on the label, then insert the color-
coded wire into the red (+) side and the other
wire into the black (–) side.
Connect the other end to the color-coded
speaker terminals on the rear of the receiver
subwoofer.
Small non-skid pads
Black (–) Red (+)
Color-coded wire
Black (–)
Color-coded wire
Color-coded tab (+)
HTP-710_VYXCN_En.book 29 ページ ２０１０年８月２３日 月曜日 午後６時４７分