Sony STR-LSA1 - Manuel (Page 4)

4 GB
Hooking Up
the System
This chapter describes how to connect
various audio components to the
receiver. Be sure to read the sections
for the components you have before
you actually connect them to the
receiver.
Unpacking
Check that you received the following items with the unit:
• AM loop antenna (1)
• Remote commander (remote) (1)
Before using the supplied remote
The supplied remote already contains a battery. Before
using the remote, pull out the insulating sheet to allow the
power to flow from the battery.
To avoid battery leakage
If you don’t use the remote for an extended period of time,
remove the battery to avoid possible damage from battery
leakage and corrosion.
z When to replace the battery
Under normal conditions, the battery should last for about 6
months. When the remote no longer operates the receiver, replace
the battery with a new one.
Notes on lithium battery
• Keep the lithium battery out of the reach of the children.
Should the battery be swallowed, immediately consult a doctor.
• Wipe the battery with a dry cloth to assure a good contact.
• Be sure to observe the correct polarity when inserting the
battery.
• Do not hold the battery with metallic tweezers, otherwise a
short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in fire.
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the AC power cords until all of the
connections are completed.
• Be sure to make connections firmly to avoid hum and
noise.
• When connecting an audio cable, be sure to match the
color-coded pins to the appropriate connectors on the
components: white (left, audio) to white; and red (right,
audio) to red.