Sony STR-LSA1 - Manuel (Page 28)

28 GB
Troubleshooting
If you experience any of the following difficulties while
using the receiver, use this troubleshooting guide to help
you remedy the problem. Also, see page 9 to verify that
the connections are correct. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound or only a very low-level sound
is heard.
, Check that the speakers and components are
connected securely.
, Make sure that you’ve selected the correct
component on the receiver.
, Press MUTING on the remote if the MUTING
indicator is lit.
, Use the i.LINK connecting cable for 200 Mbps
transmission rate.
, The protective device on the receiver has been
activated because of a short circuit. Turn off the
receiver, eliminate the short-circuit problem and
turn kn the power again.
The left and right sounds are unbalanced or
reversed.
, Check that the speakers and components are
connected correctly and securely.
, Adjust speaker balance using Sound Menu (page
16).
Severe hum or noise is heard.
, Check that the speakers and components are
connected securely.
, Check that the connecting cables are away from a
transformer or motor, and at least 3 meters away
from a TV set or fluorescent light.
, Move your TV away from the audio components.
, The connectors are dirty. Wipe them with a cloth
slightly moistened with alcohol.
Recording can’t be done.
, Check that the components are connected correctly.
Radio stations can’t be tuned in.
, Check that the antennas are connected securely.
Adjust the antennas and connect an outdoor
antenna if necessary.
, The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
manual tuning.
, No stations have been preset or the preset stations
have been cleared. Preset the stations (see page
19).
Additional
Information