Sony STR-LSA1 - Manuel (Page 14)

14 GB
Adjusting the
Sound
This chapter describes how to use the
Sound Menu to adjust the equalizer
parameters and speaker balance. The
adjusted equalizer parameter can be
stored in the memory of the receiver
for later recall.
All sound adjustments can be made with the Sound
Menu. The Sound Menu contains following submenus:
EQ BANK submenu
Nine preset settings are stored and can be recalled using
this submenu. EQ1 to 5 stores five three-band equalizer
settings; Parametric EQ1 to 3 stores three parametric
equalizer settings; and EQ FLAT stores one flat pattern.
EQ Control submenu
After selecting one of the three-band equalizer settings
stored in EQ1 to 5 through the EQ BANK submenu, you
can change the bass, midrange, and treble parameters of
the selected setting through the EQ Control submenu.
The EQ Control submenu can be accessed only after you
have selected one of the three-band equalizer settings (i.e.,
a setting stored in EQ1 to 5).
EQ Condition submenu
After selecting one of the parametric equalizer settings in
Parametric EQ1 to 3 and EQ FLAT through the EQ BANK
submenu, you can check the level, frequency, and slope of
each band.
The EQ Condition submenu can be accessed only after
you have selected one of the parametric equalizer patterns
(i.e., a setting stored in Parametric EQ1 to 3 and EQ
FLAT).
Note that you can check, but can’t change the parameters
using the receiver. You can change the parametric
equalizer settings only from a personal computer, etc.,
connected through the i.LINK network.
EQ Memory submenu
After adjusting the bass, midrange, or treble parameter of
a three-band equalizer setting, you can store the changed
setting to EQ1 to 5 with the EQ Memory submenu.
SP. Balance submenu
Use this submenu to adjust the speaker balance.
z
What is a three-band equalizer?
It’s a kind of an equalizer that provides separate adjustments of
the bass, midrange, and treble levels.
z What is a parametric equalizer?
It’s a kind of an equalizer that specifies up to three points as the
center frequencies and selects slope type for each center
frequency.