Sony STR-LSA1 - Manuel (Page 18)

18 GB
Receiving Br
oadcasts
FUNCTION +/–
FM MODE SHIFT
BAND
PRESET +/–
?/1
–
–
+
–
+
–
+
–
+
. >
N
. >
N X x
+
+ –
X x
Brief descriptions of buttons on the
remote used to receive broadcasts
PRESET +/– buttons: Press to select a preset station.
BAND button: Press to select the FM or AM band.
SHIFT button: Press to select a memory page (A, B, or C)
for presetting radio stations or tuning to preset stations.
FUNCTION +/– buttons: Press repeatedly to select the
tuner.
FM MODE button: If “STEREO” flashes in the display
and the FM stereo reception is poor, press this button to
improve the sound. “MONO” lights up in the display
and you will not be able to enjoy stereo effect, but the
sound will be less distorted.
Note
If “MONO” appears in the display even when the FM broadcast
is received normally, press this button to turn off the “MONO”
indication.
z
When you tune to a station that provides RDS services
The program station name appears in the display.
Notes
• RDS may not work properly if the station you tuned to is not
transmitting the RDS signal properly or if the signal strength is
weak.
• After you disconnect the AC power cord of the receiver, RDS
program station names may not be saved correctly. To prevent
this, preset the RDS stations (page 19).
Manual Tuning
For details on the buttons and controls used in this
section, see “Brief descriptions of buttons and controls on
the receiver used to receive broadcasts” on page 17 and
“Brief descriptions of buttons on the remote used to
receive broadcasts” on this page.
1
Press JOG MENU repeatedly until a component
name appears in the display.
2
Rotate the jog dial until “TUNER” appears in the
display.
The last received station is tuned in.
3 Press BAND to select the FM or AM band.
4
Press TUNE MODE repeatedly until “MANUAL”
lights up in the display.
5 Rotate the jog dial.
Rotate the dial clockwise to increase the tuning
frequency. Rotate it counterclockwise to decrease the
tuning frequency.
When the receiver reaches the end of either
band
Tuning starts over again in the same direction.
6
If you tune in an AM station, adjust the AM loop
antenna to optimize the reception.
7
Repeat steps 3 to 6 to tune in another station.
z You can change to the tuner quickly
Press BAND on either the receiver or the remote. Or press
FUNCTION +/– on the remote repeatedly until “TUNER”
appears in the display.
z If you try to tune more precisely than is possible for the
tuning scale
You won’t be able to tune in the exact frequency. The receiver
scans frequencies in the following units:
FM: 50 kHz
AM: 9 kHz