Sony STR-LSA1 - Manuel (Page 19)

19 GB
Receiving Br
oadcasts
Preset Tuning
For details on the buttons and controls used in this
section, see “Brief descriptions of buttons and controls on
the receiver used to receive broadcasts” on page 17 and
“Brief descriptions of buttons on the remote used to
receive broadcasts” on page 18.
Before tuning to preset stations, be sure to preset them by
performing steps on “Presetting radio stations” below.
Presetting radio stations
1 Press JOG MENU repeatedly until a component
name appears in the display.
2 Rotate the jog dial until “TUNER” appears in the
display.
The last received station is tuned in.
3
Tune in the station that you want to preset using
Manual Tuning or Automatic Tuning (page 18 and
this page).
4
Press JOG MENU repeatedly until “Setup Menu”
appears in the display.
5 Rotate the jog dial until “Preset Memory” appears
in the display, and press ENTER.
“MEMORY” lights up in the display for several
seconds. Do steps 6 and 7 before “MEMORY” turns
off.
6
Rotate the jog dial to select the memory page and
preset number.
The memory page appears and the preset number
flashes. The memory page and preset number
indication changes each time you rotate the jog dial as
follows:
t A1yA2y...yA0yB1yB2y...yB0T
t C0y...yC2yC1T
To select the memory page quickly
Press SHIFT on the remote repeatedly.
If “MEMORY” turns off or preset number stops
flashing before you select the memory page and preset
number, start again from step 4.
Automatic Tuning
For details on the buttons and controls used in this
section, see “Brief descriptions of buttons and controls on
the receiver used to receive broadcasts” on page 17 and
“Brief descriptions of buttons on the remote used to
receive broadcasts” on page 18.
1
Press JOG MENU repeatedly until a component
name appears in the display.
2
Rotate the jog dial until “TUNER” appears in the
display.
The last received station is tuned in.
3 Press BAND to select the FM or AM band.
4
Press TUNE MODE repeatedly until “AUTO” lights
up in the display.
5 Rotate the jog dial.
When you rotate the dial clockwise, the receiver scans
from low to high; when you rotate it counterclockwise,
the receiver scans from high to low.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
6
To continue scanning, rotate the jog dial again.
z You can select the tuner quickly
Press BAND on either the receiver or on the remote. Or, press
FUNCTION +/– on the remote repeatedly until “TUNER”
appears in the display.