Additional information, Troubleshooting – Sony NEX-VG20H Manuel d'utilisation

Page 64

Advertising
background image



US

Additional information

Troubleshooting

If you run into any problems using your

camcorder, follow the steps below.

 Check the list (p. 64 to 66), and

inspect your camcorder.

 Remove the power source, attach

the power source again after about 1
minute, and turn the camcorder on.

 Press RESET (p. 76) using a pointed

object, and turn the camcorder on.
If you press RESET, all settings,

including the clock setting, are reset.

 Contact your Sony dealer or local

authorized Sony service facility.

See the “Handycam” Handbook (p. 63) for

details on the symptoms of your camcorder,

and “PMB Help” (p. 49) on connecting your

camcorder to a computer.

The power does not turn on.

Attach a charged battery pack to the

camcorder (p. 16).

Connect the plug of the AC Adaptor to the

wall outlet (wall socket) (p. 17).

The camcorder does not operate even

when the power is set to on.

It takes a few seconds for your camcorder to

be ready to shoot after the power is turned on.

This is not a malfunction.

Disconnect the AC Adaptor from the wall

outlet (wall socket) or remove the battery

pack, then reconnect it after about 1 minute.

If your camcorder still does not work, press

RESET (p. 76) using a pointed object. (If you

press RESET, all settings, including the clock

setting, are reset.)

The temperature of your camcorder is

extremely high. Turn off the camcorder and

leave it for a while in a cool place.

The temperature of your camcorder is

extremely low. Leave the camcorder with the

power turned on. If you still cannot operate

your camcorder, turn off the camcorder and

take it to a warm place. Leave the camcorder

there for a while, then turn on the camcorder.

Your camcorder gets warm.

Your camcorder may become warm during

operation. This is not a malfunction.

The power abruptly turns off.

Use the AC Adaptor (p. 17).

Turn on the power again.

Charge the battery pack (p. 16).

Pressing START/STOP or PHOTO does not

record images.

Press MODE to turn on the (Movie) or

(Photo) lamp.

Your camcorder is recording the image you

have just shot on the memory card. You

cannot make any new recordings during this

period.

The recording media is full. Delete

unnecessary images (p. 44).

Total number of movie scenes or photos has

exceeded the recordable capacity of your

camcorder (p. 67). Delete unnecessary images

(p. 44).

The recording stops.

The temperature of your camcorder is

extremely high/low. Turn off your camcorder

and leave it for a while in a cool/warm place.

“PMB” cannot be installed.

Check the computer environment or

installation procedure required to install

“PMB” (p. 46).



Advertising
Ce manuel est liée aux produits suivants: