Sony KDL-52S4100 Manuel d'utilisation

Fixation du téléviseur au mur, Installing the tv on a wall

Advertising
background image

Step 4: Preparing for the

installation of the TV

Disconnect all the cables from the TV.

1

Secure the Mounting Hook to the
rear of the TV.

Referring to the Screw and Hook locations diagram/
table on the reverse page, determine the screw positions,
and secure the Mounting Hook to the rear of the TV.

1

Secure the Mounting Hook to the rear of the
TV temporarily, using the supplied four
screws (+PSW6

× 16).

2

Be sure that both screws are securely tightened
with equal torque strength to the rear of the TV.

Align the tab on the rear of the Mounting Hook
with the square hole on the rear of the TV as in
the illustration below.

Notes

• Be sure not to use any screws other than the supplied

ones (+PSW6

× 16) when securing the Mounting Hook.

• If an electric screwdriver is used, set the torque to

tighten at approximately 2.0 N·m {20 kgf·cm}.

Installing the Wall-Mount Bracket

To Customers

For product protection and safety reasons, Sony strongly recommends that installing of your TV be
performed by Sony dealers or licensed contractors. Do not attempt to install it yourself.

Your KDL-40S4100/KDL-46S4100/KDL-52S4100 can be installed using the SU-WL500 Wall-Mount
Bracket (sold separately). Please provide your licensed contractor with this installation supplement as
well as the Instructions (supplied with the SU-WL500 Wall-Mount Bracket). Read these documents
carefully for safety and proper installation.

To Sony Dealers and Contractors

Provide full attention to safety during the installation, periodic maintenance and examination of this product.

Installation du support de fixation murale

À l’attention des clients

Par souci de protection du produit et pour des raisons de sécurité, Sony recommande vivement que
l’installation du support de fixation murale du téléviseur soit confiée à un revendeur Sony ou à un
installateur agréé. Ne pas tenter d’effectuer l’installation soi-même.

Le KDL-40S4100/KDL-46S4100/KDL-52S4100 peut être installé à l’aide du support de fixation
murale SU-WL500 (vendu séparément). Veuillez fournir à l’installateur agréé ce supplément ainsi que
le mode d’emploi (accompagnant le support de fixation murale SU-WL500). Lire attentivement ces
documents qui concernent la sécurité et l’installation correcte du support.

À l’intention des revendeurs Sony et des installateurs

Accorder une attention particulière à la sécurité lors de l’installation, de l’entretien périodique et de la
vérification de ce produit.

KDL-40S4100
KDL-46S4100
KDL-52S4100

Français

English

© 2008 Sony Corporation

Printed in Mexico

3-870-415-21(1)

Installing the TV on a wall

The TV can be installed on a wall by attaching a Wall-
Mount Bracket (sold separately).
Verify your TV’s model number and be sure to use the
bracket specified for your model only. Refer to the
Steps on this leaflet along with the Instructions
supplied with the SU-WL500 Wall-Mount Bracket, to
properly carry out the installation.

For product protection and safety reasons, Sony
strongly recommends that you use the Wall-Mount
Bracket model designed for your TV and that the wall-
mounting of your TV is performed by Sony dealers
or licensed contractors.

Sufficient expertise is required in installing this
product, especially to determine the strength of the
wall for withstanding the TV’s weight. Be sure to
entrust the attachment of this product to the wall
to Sony dealers or licensed contractors and pay
adequate attention to safety during the installation.
Sony is not liable for any damage or injury caused
by mishandling or improper installation.

Step 1: Checking the parts required

for the installation

Open the Wall-Mount Bracket package and check the
contents for all required parts along with the Instructions.

Step 2: Deciding on the

installation location

Decide where you want to install your TV. Refer to the
reverse page for the TV installation dimensions table.
Refer to the Instructions for SU-WL500.

Step 3: Installing the Base

Bracket on the wall

Refer to the Instructions for SU-WL500.

English

Hexagon wrench

2

Adjust the angle of the Mounting
Hook using the hexagon wrench
supplied with the Wall-Mount Bracket.

When installing the TV parallel to the wall (0
degrees), adjustment of the Mounting Hook angle
(procedures 1 and 2 below) is not necessary. Make
sure that each arm base X is screwed in securely.

1

Remove the two screws from the arm base X of the
Mounting Hook. Choose the holes corresponding to
the desired angle (5, 10, 15 or 20 degrees).

2

Adjust the angles of the top Y and bottom Z
arm to fit the corresponding hole, and firmly
secure each arm using the two screws
removed in the previous procedure 1.

Notes

• Be sure to adjust the right and left arms to the same angle.
• Make sure that the two arm bases are screwed in securely.

CAUTION

Be careful not to pinch your fingers when adjusting
the angle of the Mounting Hook.

Français

Fixation du téléviseur
au mur

Le téléviseur peut être fixé au mur à l’aide du support
de fixation mural (vendu séparément).
Vérifier la référence du modèle du téléviseur et
s’assurer à utiliser uniquement le support spécifié
pour ce modèle. Consulter les étapes de ce dépliant
ainsi que le mode d’emploi accompagnant le support
de fixation mural SU-WL500 pour effectuer
correctement l’installation.

Pour des raisons de sécurité et de protection du
téléviseur, Sony recommande fortement que vous
utilisiez le modèle de support de fixation murale
conçu pour votre appareil, et que l’installation soit
effectuée par un détaillant Sony ou un représentant
agréé.

Une certaine expertise est requise pour installer ce
produit, notamment pour déterminer la résistance
du mur par rapport au poids du téléviseur.
S’assurer de confier la fixation de ce produit au
mur à des revendeurs Sony ou à des installateurs
agréés et d’être particulièrement vigilant en
matière de sécurité au cours de l’installation. Sony
ne peut être tenu responsable de tout dommage
ou blessure résultant d’une manipulation ou
d’une installation incorrecte.

Étape 1 :Vérification des pièces

requises pour l’installation

Ouvrez l’emballage du support de fixation murale et
vérifiez que toutes les pièces nécessaires sont
présentes ainsi que le mode d’emploi.

Étape 2 :Choix de l’emplacement

d’installation

Décidez de l’emplacement où vous voulez installer
votre téléviseur. Voir le verso de la page pour consulter
le tableau des dimensions d’installation des téléviseurs.
Reportez-vous au mode d’emploi du SU-WL500.

Étape 3 : Installation au mur du

support de fixation de
la base

Reportez-vous au mode d’emploi du SU-WL500.

3

Remove the screws from the rear
of the TV. Then detach the Table-
Top Stand from the TV.

CAUTION

Make sure that you carry out this task with two or
more people.

Step 5: Installing the TV on the wall

Refer to the instructions for SU-WL500.

Notes

• When you put the TV back on the stand, reverse the above

steps (insert the posts of the stand, aligning with the lines
on the rear of the TV).

• When moving the TV, do not squeeze the bottom of the

front panel too strongly.

• Remove the screws or install the Mounting Hook on a

stable and level surface.

Screw
(+PSW6

× 16)

Mounting Hook

Square
hole

Square
hole

Tab

Étape 4 :Préparation de l’installation

du téléviseur

Débranchez tous les câbles du téléviseur.

1

Fixez le crochet de fixation à
l’arrière du téléviseur.

En vous reportant au schéma/tableau des
emplacements des crochets et des vis au verso de
la page, déterminez les emplacements des vis et
fixez le crochet de fixation à l’arrière du téléviseur.

1

Fixez temporairement le crochet de fixation à
l’arrière du téléviseur à l’aide des quatre vis
fournies (+PSW6

× 16).

2

Assurez-vous que les deux vis sont serrées
convenablement, au même couple, à l’arrière
du téléviseur.

Alignez la patte située à l’arrière du crochet de
fixation sur l’orifice carré au dos du téléviseur,
de la manière illustrée ci-dessous.

Vis
(+PSW6

× 16)

Crochet de
fixation

Orifice
carré

Orifice
carré

Patte

Advertising
Ce manuel est liée aux produits suivants: