Sony KDL-32R420B - Manuel (Page 8)

8 US
D:\SONY TV\SY140048_Clover 29 (Rev-1)\4528762121_US\040GES.fm masterpage: Left
KDL-48R470B / 40R470B / 32R420B
4-528-762-12(1)
Connecting the TV
You can enjoy high-definition and standard-
definition digital programming (if available in your
area) along with standard-definition analog
programming.
This TV is capable of receiving unscrambled digital
programming for both cable (QAM and 8VSB) and
external VHF/UHF antenna (ATSC).
Cable or VHF/UHF (or VHF only)
Note
• It is strongly recommended that you connect the CABLE/
ANTENNA input using a 75-ohm coaxial cable to receive
optimum picture quality. A 300-ohm twin lead cable can
easily be affected by radio frequency interference,
resulting in signal degradation.
Use an optional A-B RF switch (not supplied) to
switch between the cable and over-the-air antenna
programming, as indicated below.
Note
• Be sure to set the Signal Type setting to Cable or
Antenna found under the Channel settings for your input
signal (page 20).
You can enjoy high-definition programming by
subscribing to a high-definition cable service or a
high-definition satellite service. For the best
possible picture, make sure you connect this
equipment to your TV via the HDMI or component
video (with audio) input located on the back of your
TV.
Shown with HDMI Connection
Cable System or VHF/UHF Antenna System
Cable System and VHF/UHF Antenna
System
75-ohm
coaxial cable
CABLE/ANTENNA
Rear of TV
B
A
A/B RF Switch
Cable
Antenna
Rear of TV
CABLE/ANTENNA
HD Cable Box/HD Satellite Box
Side Panel
Set Top Box